需要金幣： 1000 個金幣 |
資料包括：完整論文 |  |
 |
| 轉換比率：金額 X 10=金幣數量， 例100元=1000金幣 | 論文字?jǐn)?shù)：12583 |  | |
| 折扣與優惠：團購最低可5折優惠 - 了解詳情 | 論文格式：Word格式(*.doc) |  |
摘 要:圓孔拉刀是孔類零件批量加工過程的專用刀具。傳統的圓孔拉刀設計多以手工繪圖為主。由于圓孔拉刀結構復雜，參數的計算量較大，繪制也非常繁瑣，制造起來就相對麻煩。而采用參數化的方法就能有效的避免這一問題。參數化設計是通過該改變圖形的某一部分或全部的尺寸，或修改已經定義好的零件參數，自動完成對圖形中相關部分的改變，從而實現對圖形的驅動。本文就是采用了參數化的方式，在UG平臺上對圓孔拉刀進行了設計。文中，先是對圓孔拉刀的概念、參數計算，及UG/OPEN這個開發平臺進行了簡要介紹。然后對圓孔拉刀在UG中的具體造型和UG的二次開發做了較為詳盡的介紹。最終得出了可以進行參數變換的圓孔拉刀三圍特征模型。 關鍵詞：圓孔拉刀，參數化，UG
Abstract:Round broach is a special tool hole parts batch processing. Round broach design traditional by manual drawing. Because the hole broach complicated structure, high parameter calculation, drawing is also very tedious, relatively trouble. Using parametric methods can effectively avoid this problem. Parametric design is through the change pattern of part or all of the size, or modifying the component parameters have been defined, automatically for the relevant part pattern change, thus to drive the graphics. This paper is the use of a parametric approach, in the UG platform is designed to round broach. In this paper, first the concept, calculation of hole broach parameter, and the UG/Open development platform are introduced in this paper. Then gives a detailed introduction of two development to specific modeling and UG round broach in UG. Finally reached the round broach measurements model parameters can be transform. Keywords：:round broach,parameterization,UG |
