需要金幣： 1000 個金幣 |
資料包括：完整論文 |  |
 |
| 轉換比率：金額 X 10=金幣數量， 例100元=1000金幣 | 論文字?jǐn)?shù)：38頁 |  | |
| 折扣與優惠：團購最低可5折優惠 - 了解詳情 | 論文格式：Adobe Reader格式(*.pdf) |  |
摘要:本文詳細介紹了垂直軸風力發電機組傳動系統的設計過程。 風電傳動系統的設計需考慮風輪慣性及發電機短路力矩及陣風等的影響，需要有風輪的載荷序列方能進行設計，所以必須先設計出風輪才有后面的一系列零部件。 風力發電機組中的傳動系統主要功用是將風輪在風力作用下所產生的動力傳遞給發電機并使其得到相應的轉速。通常風輪的轉速很低，遠達不到發電機發電所要求的轉速，必須通過傳動系統齒輪副的增速作用來實現。根據機組的總體布置要求，有時將與風輪輪轂直接相連的傳動軸（俗稱大軸）與傳動系統合為一體，也有將大軸與傳動系統分別布置，其間利用漲緊套裝置或聯軸節連接的結構，本設計選擇后一種方式，以便于作為傳動系統的增速箱的制造、安裝以及維護。 具體方案選擇一級直齒圓柱齒輪增速，結構簡單，穩定性高，維護方便。安裝結構方面，傳動系統的輸入和輸出軸均與大軸平行，考慮到系統的功率負載不大，齒輪的轉速也比較低，可選擇脂潤滑，同時解決了齒輪箱側置會產生的漏油問題。 關鍵詞：垂直軸風力發電機，傳動系統，增速
Abstract:This paper mainly introduces the transmission system of vertical axis wind turbo generator designing. The design of transmission system of vertical axis wind turbo generator should consider the inertia of the wind wheel， even the impact of short circuit moment of the motor and flatus， and it impossible without the data of wind wheel’s load. So the wind wheel must be designed before the following steps. The function of the transmission system is to transfer the power from the wind wheel to the generator and endow it a corresponding rev. Normally the rev of the wind wheel is quite low and can not satisfy the generator’s demand，so there must be a transmission system to raise the out-put rev[3]. According to the demand of layout of the generator， the main axis is either combine with the transmission system or separated and connect to the in-put axis of the gearbox with a coupling. In this case the latter project is adopted to make it easier to manufacture， install and maintenance. The detail idea is use a single stage straight toothed spur gear transmission. The advantages of the idea is to make the system simple， steady and easy to maintain. The output axis and input axis are parallel to the main axis. The power of the system is not so strong and the rev of the axises is not very high， so the system will lubricated with grease and at the same time solve the problem of oil leaking. Key words: vertical axis wind turbo generator， transmission system， speed-up
|
